Fire-magic Aurora Single Sideburner Slide-in 3279 Series User Manual download pdf (Page 14)

L-C2-189

REV 7 - 1407151420

Air shutters are preset at the factory based on the

gas the sideburner is built to burn. However, altitude

or other local conditions may require air shutter

adjustment for proper combustion.

The ﬂ ames from a properly adjusted sideburner

will touch the burner ports and appear mostly blue.

If they are orange, “lazy,” or lift off the burner ports,

then adjust the sideburner air shutter using the

following steps.

The air shutter is located at the end of the burner

assembly, behind the control panel. It can safely

and easily be adjusted while the unit is lit.

CAUTION: Do not touch the sideburner

surrounding top area, as it will be

hot while adjusting the air shutter.

1. Remove the control knob and screws ﬁ rst, then

carefully lift away the control panel.

Important: Prior to fully removing the control

panel, you must disconnect the

battery holder assembly wires that

are located behind the control panel.

2. Replace the control knob back on to the valve

stem.

Light the sideburner following the LIGHTING

INSTRUCTIONS section.

4. Loosen the front burner air shutter adjustment

screw, then use the tip of a screwdriver to open

or close the air shutter until the ﬂ ames appear

blue and touch the burner ports.

5. Retighten the adjustment screw.

6. Once adjustment is complete; be sure the

unit is off and remove the knob, then replace

the control panel, being sure to reconnect

the battery holder assembly wires. Replace

the control knob.

Open

AIR SHUTTER ADJUSTMENT

Fig. 14-2 Air shutter adjustment

Fig. 14-1 Flame pattern

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Fire-magic Aurora Single Sideburner Slide-in 3279 Series User Manual Page 14